308 150gr Flat Point Bullets, .308 diameter. These bullets are new plated bullets. Entire bullet is plated so there is no exposed lead. Please note that these are plated bullets and may not perform well at normal 308 velocities. Low velocity Blackout, 308 and 30-30 are good choices for this bullet.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to - www.P65Warnings.ca.gov
-
Feeding issuesI bought 1000 rounds and loaded about 100. They didn't cycle in my M4 correctly and they were not very accurate at 100 yards. Everglades has great service, they took back the unused rounds and replaced them with a different round of my choice. Five Stars on service, no stars on this round.
-
Great practice bullet for 30/30Bought 100 of these bullets as a trial. I am taking my daughter hunting this winter and must train her to shoot the old beat up 94. Loaded to standard lead bullet velocity with 27 grains of aa2460 ( needed a good use for this old pound of powder) per the old lee reloading manual. Test fired 10 rounds myself. As accurate as can be expected in the old 94. Definately a low recoil round. Great for training, great price, absolutely no complaints on these bullets. I will order a larger quantity monday if she does well this weekend when she starts training. Maybe even put some in a pig if we get lucky enough to get a shot at one this weekend..
-
excellentGreat economical bullet for reloading subsonic 308 rounds! Hope they can keep these in stock!
Doug Hand -
Excellent for 30-30I have been shooting this bullet for about a month now with very good results. Currently using 2400 powder and a Winchester 94AE resulting in 1825fps. Very accurate out to 175 yards; Able to hit tennis balls 4 out of 5 rimes at least. This will be my go to 30-30 bullet. Thanks
-
308 150gr Flat Point Plated Bullets308 150gr Flat Point Plated Bullets very well made and Great customer service and shipping
-
good so fartried these in my ar 300 blackout have not tried for accuracy just function and feeding. seem to feed good, will do more testing. running accurate 5744 with a 2.060 overall length. hard to find good data on rounds like this online but this site definatly seems to have some of the best feedback for 300 blackout ive seen so far
-
my grandson shot a deer at 50 yards with 30-30 your bullets deer right down we like emwill buy again great for 30-30 deer at 50 yards went straight down we like em
-
Price is great, performance decentGetting maybe 1/2 inch two shot groups to 1-2 inch 5 shot groups at 50 yds with 15 gr RX7, chrono about 1400 ave. Occasional flyers, possible keyhole. Notice lead smudge on the target so wondered if the plating is stripping? Getting some odd holes with sharp square edges at end of session, barrel a little warm. . Bore is relatively clean, little to no fouling after 60+ rounds. This is a 1958 vintage 94 so I don't expect a lot. Checked seat, right at throat. Using Lee factory crimp, puts slight dent on pulled bullet. May lighten up on the crimp. Price is right compared to laser cast and added step of running through sizing with gas check. Good plinker. round.
-
300 blk ar seems good for plinking.Tried out 10 of these for my 300 blk 16" ar with a pistol length gas system and even though they were subsonic they cycled fine and held open on the last shot. I used a 30 rd pmag if that's helpful.
-
Gotta crimp 'em hard for 94 30-30Bought 1000 of them and the delivery and service from Everglades was great. Bought them for plinking and you have to really put a hard crimp on them to keep them from pushing back into the casing in my tube magazine. Would be nice if they had a cannelure. My rcbs and lee dies tended to wrinkle the case necks before getting a good grip on them. Had to buy a Lee factory crimp die to keep the slippery little buggers from sliding. Set hard, it makes its own cannelure. They can be loaded to be accurate.